"Mid Valley Treasure Hunters"      

"Detecting Equipment"

Past Archives

""User comments and opinions are welcomed here."
This site is not sponsored by any dealer or manufacturer of detecting equipment. Everyone is encouraged to speak out in a responsible manner expressing both good and bad experiences with any make, model or brand detector or accessory. Our mission is to increase the knowledge base of all readers by sharing our collective insight and to provide sound advice without editorial bias.

"River Team Six Detectors"     "Indian Nations Detectors"     "Back Woods Detectors"

Golden Umax and Ground Balance (- General)

by metalprobe ⌂ @, hongkong, Wednesday, April 27, 2016, 03:30 (839 days ago) @ Sven

air, sand, mud, rock are totally different media
and pinpointer need direct contact with these media to locating the targets

Stepless sensitivity adjustment is the best solution but this will raise cost of production

normally pinpointer factory offer auto adjustment for 3 or 4 level to solve the faulty alarm
when the probe hunting in different media or move place to place

So I suggest you can put pinpointer into the media 1 inch than adjust sensitivity and this will
give you best detecting experience :-)


Complete thread:

 RSS Feed of thread

powered by my little forum