"Mid Valley Treasure Hunters"      

"Detecting Equipment"

Past Archives

""User comments and opinions are welcomed here."
This site is not sponsored by any dealer or manufacturer of detecting equipment. Everyone is encouraged to speak out in a responsible manner expressing both good and bad experiences with any make, model or brand detector or accessory. Our mission is to increase the knowledge base of all readers by sharing our collective insight and to provide sound advice without editorial bias.

"River Team Six Detectors"     "Indian Nations Detectors"     "Back Woods Detectors"

move in sand or mud or rock area must pass torque test (- General)

by metalprobe ⌂ @, hongkong, Wednesday, April 27, 2016, 03:14 (875 days ago)
edited by metalprobe, Wednesday, April 27, 2016, 06:45

I found when the probe hunting in sand or mud
faulty alarm will occur if the pinpointer sensitivity adjust to max.

so metalprobe designed to withstand the torque from different direction


Two dumbbells Total weight: 20KG! when sensitivity adjusted to max level



Complete thread:

 RSS Feed of thread

powered by my little forum